background image

Installation instructions

Built-in variants of gas hob

Dials GAS641/731

1014402-10

26/07/2023

1014402-10

1

The appliance must be installed by qualified personnel only. Each step must be carried out and checked in full in the
order specified.

Check that the local connection conditions (gas type and gas pressure) and the appliance setting match before con-
necting the appliance.

The default values for this appliance are provided on the information plate (or on the identification plate).

This appliance is not connected to a combustion by-product outlet. It must be set up and connected according to the
applicable installation conditions. Particular attention must be paid to the relevant ventilation requirements.

If installing into a combustible material, the guidelines and standards for low-voltage installations and fire protection
must be strictly observed.

All leak tests should be done with a soapy water solution. Never use an open flame to check for leaks!

Validity

These installation instructions apply to the following models:

Model number

Type

Appliance class

31089

GAS641GKAZ

Class 3

DIN EN 30-1-1

31075

GAS731GKBZ

General notes

Identification plate

The identification plate and stickers with the permissible
gas types and safety precautions are located on the under-
side of the hob.

Identification plate

Depending on 
appliance, plate 
with additional 
information

Affix the second identification plate (supplied) in an accessible position behind the front of the fitted cabinet beneath the appliance.

Care and maintenance

Follow the care and cleaning advice in the operating instructions.

Follow the basic maintenance advice in the operating instructions.

Содержание GAS641









Отзывы: