Zanussi ZCG92496XA, Руководство пользователя

Страница: 21 / 28

Problem Possible cause Remedy
There is no spark when you try
to activate the spark generator.
The hob is not connected to an
electrical supply or it is con-
nected incorrectly.
Check if the hob is correctly
connected to the electrical
supply. Refer to the connection
diagram.
There is no spark when you try
to activate the spark generator.
The fuse is blown. Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
There is no spark when you try
to activate the spark generator.
Burner cap and crown are
placed incorrectly.
Place the burner cap and
crown correctly.
The flame extinguishes immedi-
ately after ignition.
Thermocouple is not heated up
sufficiently.
After lightning the flame, keep
the spark generator activated
for equal or less than 10 sec-
onds
The flame ring is uneven. Burner crown is blocked with
food residues.
Make sure that the injector is
not blocked and the burner
crown is clean.
The burners do not work. There is no gas supply. Check the gas connection.
The flame colour is orange or
yellow.
The flame can look orange or
yellow in some areas of the
burner. This is normal.
The oven does not heat up. The oven is deactivated. Activate the oven.
The lamp does not operate. The lamp is defective. Replace the lamp.
Steam and condensation settle
on the food and in the cavity of
the oven.
You left the dish in the oven for
too long.
Do not leave the dishes in the
oven for longer than 15 - 20
minutes after the cooking
process ends.
The oven does not heat up. The clock is not set. Set the clock.
The oven does not heat up. The necessary settings are not
set.
Make sure that the settings are
correct.
The turnspit does not rotate. The turnspit is not correctly in-
stalled into the turnspit hole.
Refer to "Using the turnspit".
It takes too long to cook the
dishes or they cook too quick-
ly.
The temperature is too low or
too high.
Adjust the temperature if nec-
essary. Follow the advice in the
user manual.
The display shows an error
code that is not in this table.
There is an electrical fault. Deactivate the oven with the
house fuse or the safety switch
in the fuse box and activate it
again.
If the display shows the error
code again, contact the Cus-
tomer Care Department.
The display shows "12.00". There was a power cut. Reset the clock.
21