Zanussi ZCG92496XA, Руководство пользователя

Страница: 8 / 28

3. Set the function and set the maximum
temperature.
4. Let the appliance operate for 15 minutes.
5. Set the function and set the maximum
temperature.
6. Let the appliance operate for 15 minutes.
Accessories can become hotter than usual. The
appliance can emit an odour and smoke. This is
normal. Make sure that the airflow in the room is
sufficient.
HOB - DAILY USE
WARNING! Refer to Safety chapters.
IGNITION OF THE HOB BURNER
Always light the burner before you put
on the cookware.
WARNING! Be very careful when you
use open fire in the kitchen
environment. The manufacturer
declines any responsibility in case of
the flame misuse.
The spark generator can start
automatically when you switch on the
mains, after installation or a power cut.
It is normal.
In the absence of electricity you can
ignite the burner manually.
Ignition of a hob burner with the
thermocouple
• For manual ignition put the flame near the
burner. Push the knob for the hob down and
turn it counterclockwise to the maximum gas
flow position .
• For integrated ignition on knob push the knob
for the hob down and turn it counterclockwise
to the maximum gas flow position .
Keep the knob for the hob pushed for equal or less
than 10 seconds to let the thermocouple warm up.
If not, the gas supply is interrupted.
Adjust the flame after it is regular.
WARNING! Do not keep the knob
pushed for more than 15 seconds. If
the burner does not light after 15
seconds, release the knob, turn it into
the off position and try to light the
burner again after minimum 1 minute.
If after some tries the burner does not
light, check if the crown and its cap
are in the correct position.
If the burner accidentally goes out,
turn the knob to the off position and try
to light the burner again after minimum
1 minute.
BURNER OVERVIEW
A
B
D
C
A
B
C D
A. Burner cap
B. Burner crown
C. Ignition candle
D. Thermocouple (if applicable)
8