Zanussi ZCG63260XE, Руководство пользователя

Страница: 27 / 32

To replace the glass panels, do the same
steps in reverse. Before you lower the
trim, attach the A trim part to the door.
Refer to the image.
12.8 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the oven. Wait until the oven is
cold.
2. Disconnect the oven from the mains.
3. Put a cloth on the bottom of the cavity.
The back lamp
The lamp glass cover is at the back of
the cavity.
1. Turn the lamp glass cover
counterclockwise to remove it.
2. Clean the glass cover.
3. Replace the oven lamp with a suitable
300 °C heat-resistant oven lamp.
Use the same oven lamp type.
4. Install the glass cover.
13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1 What to do if...
Problem Possible cause Remedy
You cannot activate the appliance. The appliance is not connected to
an electrical supply or it is connec‐
ted incorrectly.
Check if the appliance is correctly
connected to the electrical supply.
You cannot activate the appliance. The fuse is blown. Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
The burners do not work. There is no gas supply. Check the gas connection.
There is no spark when you try to
activate the spark generator.
Burner cap and crown are placed in‐
correctly.
Place the burner cap and crown cor‐
rectly.
The flame extinguishes immediately
after ignition.
Thermocouple is not heated up suf‐
ficiently.
After lightning the flame, keep the
knob pushed for equal or less than
10 seconds.
The flame ring is uneven. Burner crown is blocked with food
residues.
Make sure that the injector is not
blocked and the burner crown is
clean.
The oven does not heat up. The oven is deactivated. Activate the oven.
The oven does not heat up. The clock is not set. Set the clock.
The oven does not heat up. The necessary settings are not set. Make sure that the settings are cor‐
rect.
ENGLISH 27