Zanussi Electrolux DCE5655, Инструкция пользователя

Страница: 7 / 20

- 7 -
Water hardness level
°d
1)
mmol/l
2)
Setting on the
water softener
Number of
light flashes
> 24 4,2
18 - 24 3,2 - 4,2
12 - 18 2,1 - 3,2
4 - 12 0,7 - 2,1
below 4 below 0,7
5
4
3 *
2
1
5
4
3
2
1
no salt is needed
1. Press the water softener and functions buttons
simultaneously and hold them pressed in, then
also press in the On/Off button.
2. When the lamps for the water softener and
functions buttons starts to flash, you can let go
of the buttons.
3. Press the water softener button once. At first the
lamp will be solid, then it starts to flash.
- The number of flashes are equivalent with the
set water hardness level.
- This sequence of flashes is repeated several
times after a few seconds pause.
4. The water hardness level is raised by 1 step
every time you press the water softener button.
After hardness level 5 comes hardness level 1.
5. Press the On/Off button when the required water
hardness level is selected. This saves the selection.
If the setting 1 is chosen, the salt indicator lamp
is not lit.
1) german degree of measurement for the water
hardness
2) millimol, internationel unit for water hardness
*) factory setting
If dishwasher detergent with rinse aid is used,
you can switch off the lamp that indicates that
the rinse aid dispenser is empty.
1. Press the water softener and functions buttons
simultaneously and hold them pressed in, then
also press in the On/Off button.
2. When the lamps for the water softener and
functions buttons starts to flash, you can let go
of the buttons.
3. Press the functions button once. The lamps for
the functions button and ended programme cycle
starts to flash. Press the button once more and
the light for the ended programme cycle goes out.
Now the function for the rinse aid control light
is off.
4. Press out the On/Off button to complete the setting.
To reset the function, follow steps 1 and 2 above
and then press the functions button twice, until
the lights for the functions button and for ended
programme cycle begin to flash again.
Adjusting the water softener
To prevent limescaling on the dishes and to the interior of the
dishwasher, the dishes must be washed with soft water.
This dishwasher is equipped with a water softener, where tap-
water which is harder than 4 °d (german degree) is softened.
Adjust the water softener according to the table below for the
water hardness level for your area.
Contact your local Water Authority to find the
exact water hardness level for your area.
The water softener has 5 settings:
In both of the following settings the dishwasher must be switched off and all programmes completed.
See chapter ”Using the appliance” for information on how to complete the programme.