Zanussi Electrolux DCE5655, Инструкция пользователя

Страница: 9 / 20

- 9 -
Starting the programme
1. Scrape or rinse off solid food remnants.
2. Load the dishwasher.
(See the basket and loading).
3. Put the correct amount of detergent into the
detergent dispenser and close the dispenser lid.
4. Close the door.
5. Press in the On/Off button.
6. Press in the required programme button (see pro-
gramme chart). Programme indicator lamp is lit.
During the six seconds the two top indicator lamps
are flashing, you can select another programme
cycle. If not, the selected programme starts.
The lamp indicates which part of the selected
cycle the dishwasher is in.
7. Check the strainers/filters to see if they need to
be cleaned when the dishwasher has finished
the programme.
If both the top and middle indicator lights are
flashing, first check that the door is properly closed,
if it is read the section ”Something Not Working”.
Stopping the programme temporarily
1. Open the door. The programme stops.
2. Top or middle indicator lamp is flashing depending
on how far the programme cycle has gone.
3. Close the door and the programme continues
after about 6 seconds.
Open the door carefully when the dishwasher is
running, since hot steam may escape.
Cancelling the programme
1. Press and hold in the button for the programme
in progress until the indicator light for the pro-
gramme goes out.
2. Release the programme button. The programme
is now cancelled and a new programme can be
selected.
If you switch the dishwasher off, the selected
programme is not cancelled, it is only interrupted.
When you start the dishwasher again, the pro-
gramme will continue.
Pause function
With the pause function the programme can be temporarily
interrupted for a short period of time.
1. Press in the On/Off button. The programme stops.
2. All lamps goes out.
3. When you want the programme to continue again,
you press the On/Off button.
The programme continues.
The programme should not be paused for any
longer than necessary, because the water inside
the dishwasher has cooled down and must be
heated again which increases the power
consumption.
Cancelling the drying phase
In case you do not want to wait until the drying phase is
completed, you can cancel it.
1. Press in the On/Off button. The control lamp for
the On/Off button goes out.
2. Open the door. The drying phase is cancelled.
Switching the dishwasher off
Do not switch the dishwasher off until the indicator lamp
for the programme cycle end is lit.
1. Press in the On/Off button. The control lamp for
the On/Off button goes out.
Be careful if you open the door immediately
after the programme is finished, since hot steam
may escape.
This dishwasher has a new feature called
”IMPULSE WASHING”. This washing system
varies both the revolutions of the pump and the
water pressure for more intensive cleaning of the
dishes during the programme. That is why different
sections of the programme cycle do not sounds
the same.
Using the appliance