ZANTIA SLIM-C Series, Инструкция по эксплуатации

Страница: 22 / 40

19
2.8.7 Insulation
All the water piping must be insulated with insulation no less than 9mm thick.
But all the valve switches need to stay outside for
future use. The insulation must be fastened by tape,
without any gap.
2.8.8 Se tting up the condensate drainage system
2.9 Test-run
2.9.1
Air purging
Connect to discharge system
A f t e r f i n i s h i n g t h e i n s t a l l a t i o n , p r o c e e d
w i t h t h e f o l l o w i n g s t e p s t o d i s c h a r g e t h e
a i r i n t h e u n i t :
①
Take out the air outlet grille .
②
. O p e n a l l v a l v e s o f w a t e r s y s t e m t o h a v e
w a t e r f l o w i n t o t h e u n i t .
③
Open air purging valve, and check the
water in a transparent pipe connected with
the valve. If the transparent pipe is filled with
water without any bubbles, the air is
completely purged from the coil. Then close
the purging valve.
.
2. Installation
The condensate drainage system must be set up with
an adequate decline, to ensure the water drain away
properly. Following are directions for setting up a
proper condensate drainage system:
Connect to the unit condensate
discharge or defrosting tray
Notice:
it's recommended to pour some water into the
drain pan very slowly. If the water can't
drain away smoothly, some adjustments
should be made.
To check if water flow is in correct direction,
Air purging valve
5
m
m