ZANOLLI SYNTHESIS 06/40V GAS, Инструкция по установке, эксплуатации и обслуживанию

Страница: 30 / 44

CLEANING
30 Synthesis 06/40V GAS
7.3 CLEANING THE BAKING CHAMBERS
To access the internal components of the baking chamber, proceed as follows:
Disconnect the power supply to the oven by turning off the mains. Use the switch on the mains
fuse box.
Remove the drawers at the entrance and exit of the wire mesh conveyor belt.
Remove the casing covering the conveyor belt transmission joint freeing it from its attachment
with an upward movement.
Rotate the wire mesh conveyor until the drive shaft pivot corresponds with the transmission
joint notch, then slide the joint towards the control panel freeing it from the conveyor belt drive
shaft.
Raise the shutters at the entrance and exit to the point of maximum aperture. Lift the wire
mesh conveyor belt from both ends and remove it in the direction of the controls.
Open the side hatch, making sure to wear a pair of heavy duty gloves to avoid getting
scratched from sharp metal corners. Take out the diffusers that are fixed with hexagonal nuts.
These need to be unbolted using a number 8 spanner.
To clean the removable parts, follow the instructions contained in paragraph 7.1. To clean
inside the baking chamber, remove food deposits with a dustpan and brush or with a vacuum
cleaner before cleaning the metal surfaces with a sponge wetted with water and a non
abrasive or corrosive detergent, then wash these surfaces with a sponge soaked in clean
water.
After cleaning the equipment reassemble all the components by following the instructions
above in reverse order.
It is recommended to clean the oven after it has been in operation for more than 200 hours..