ZANOLLI SYNTHESIS 06/40V GAS, Инструкция по установке, эксплуатации и обслуживанию

Страница: 15 / 44

INSTALLATION
15 Synthesis 06/40V GAS
equipment is installed. The drawing in of combustion air and the expelling of
combustion exhaust takes place in the room where the oven is installed.
To install type “A1” equipment, rooms in which it is housed must be aerated
and ventilated. They must specifically respect the conditions concerning the flow of air
necessary for combustion and aeration of these spaces and for the disposal of
combustion residue.
ATTENTION! Carry out the installation of the oven according to the standard
defined by the norms in force for this type of equipment in the country in which it is
being installed. For more information refer to these norms.
To find out the nominal heat input of your oven, see Tab 3.1. When more than
one or more cooking units are stacked one on top of another, to calculate the nominal
heat input simply sum the power of each single unit.
The area in which the units will be housed must have at least two permanent apertures
leading directly through its walls leading into the open air:
- one for the intake of combustion air, ventilating the room
- the other for disposing of combustion gasses, aerating the room
The two apertures must be in such a position so as not to create a short-circuit in the flow of
air: preferably they should be at opposite ends of the room, they must not be obstructed and
must be protected with grilles.
The necessary aeration can be achieved naturally or by way of the installation of a forced
aeration system depending on the norms in force in the country where the installation is being
made for ovens with a type “A1” exhaust.
Be aware of the total nominal heat input of the ovens housed in each room in a
situation in which more than one unit is being installed.
The manufacturer cannot answer for damage caused by ignoring these
abovementioned norms as well as the information in this manual.