ZALMAN LQ1000 Скачать руководство пользователя страница 8

Страница: 8 / 10

5.1 Adding Coolant

5.2 Coolant Circulation

5. Leakage Inspection and Test Run

(1) Remove the Reservoir Cap by turning counter-clockwise.
(2) Mix half 125cc of the provided coolant 250cc with 500cc of distilled water in a container.
(3) Secure the Funnel in the Pouring Hole and carefully pour coolant up to the Reservoir

Window’s “High Level” mark.

(1) To provide the necessary power (12V DC) for your Test Run and Leakage Inspection,

please disconnect the PSU’s Main Connector (20P/24P) and 4-Pin CPU ancillary
connector from the motherboard and use the provided Jump Cable to connect the Main
Connector’s (20P/24P) green wire terminal to a black wire ground terminal.

(2) Connect the Display PCB’s 4-Pin power connector and the PSU’s 4-Pin connector.
(3) When power is supplied, the front panel display/gauges will light up red and the Left Door’

Flow Indicator will light up blue with a spinning impeller.

(4) For discharging of gas and good coolant circulation, turn the Power Supply ON/OFF

approximately 3~7 times at 10 second intervals.

(5) Check for leakage at each inlet/outlet. Leakage can lead to short-circuiting and/or damage

to the motherboard or other components. If leaking is discovered, turn OFF the power,
completely remove any leaked coolant, and reassemble the leaking section.

(6) Coolant Level will drop when the coolant begins circulating. Please pour additional coolant

up to the Reservoir Window's “High Level” mark.

(7) After degassing is complete, detach the PSU’s power connection. Use a coin-like object

to secure the Reservoir Cap to prevent leaking.

(8) Lay the LQ1000 on its right side
(9) Reinstall the Water Block that were removed from the motherboard for degassing.

(10) Connect the PSU’s Main Connector and the CPU 4-Pin Connector to the motherboard.
(11) To prevent coolant leakage the LQ1000 Must be set upright on its feet before proceeding

with the next step (12).

(12) After setting the LQ1000 upright on its feet, remove the Sealing Bolt from the Reservoir

Cap and secure the Sealing Bolt in the adjacent Sealing Bolt Tap Hole.

Note 1) Please prevent coolant spillage by carefully pouring with the provided Funnel. Coolant Level will

drop when the coolant begins circulating. please pour additional coolant up to the “High Leve”
mark.

Note 2) The provided coolant is a concentrated liquid. please dilute the coolant with distilled water in a 1:4

ratio.

Note 3) Read the warning label on the coolant’s container prior to use.
Note 4) Keep the LQ1000 and its components away from children.

Note) Cable organization is necessary to prevent interference with tubes when the Left Door.

Reservoir Cap

4-Pin Connector

Power Supply
4-Pin Connector