ZADI RTS Bike, Инструкция по эксплуатации, Страница: 17 / 26

Central unit set-up menu
Tyre sensors learning procedure
Units of measure set up
Memorization of the pressure reference value
(picture no. 3)
Before entering the set up menu make sure the central unit is completely off. Push and keep on pushing S2 and, at the same time, start the central unit by pushing S1.
It is now possible to scroll the menu pages by shortly pressing the S2 button. To access a specific page of the menu shortly press S1. Once in the menu, if no button is
pushed within 30 seconds, the central unit automatically returns to its normal functions.
All procedures must be completed within their maximum time frame. If this time limit is exceeded, the procedure will be terminated without being completed.
(picture no. 4)
The central unit and the tyre sensor have already been matched by the producer. If the memorization of a new sensor is necessary, follow the procedure described
here below:

Enter the “1 SL” menu. The icon of the front tyre will start flashing. If you wish to switch to the rear sensor, shortly push S2. Deflate the front tyre until the
pressure value is lower than 0,9 bar (13 psi) and higher than 0,4 bar (6 psi).
 Press S1. The led will shortly flash and the front tyre icon will become fixed. The code of the front tyre sensor has been recognized and stored in the memory.
 The rear tyre symbol will start flashing. To exit without executing the procedure for the rear tyre press S2.
 Now follow the same procedure described for the front tyre.

Once the procedure has been completed the central unit automatically returns to ACTIVE mode.
(picture no. 5)
The units of measure memorized during production for pressure and temperature are “BAR” and “°C”. It is possible to change these into “PSI” and “°F”.
 Enter the “2 Un” menu.
 The symbols of the memorized unit of measure will start flashing. Push S1 to confirm these units of measure; your choice will be confirmed by a short flashing of the
led. To change units of measure push S2 and then to confirm your choice shortly pushing S1; the led will shortly flash.
The pressure reference value gives a point of reference to the central unit for the calculation of the warning and alarm thresholds respectively fixed at ±7,5% and ±15%
17
Manuale Istruzioni RCS Bike - ITA/ENG/TED