DOC-USR-0027-10
___________________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
45
the path/name of the H264 file in “Dest Address”
(for example: /media/sda1/example.h264). If
audio is enabled, a companion .aac file is then
created (for example, for “example.h264” a
companion file “example_0.aac” is created).
MPTS will be supported in an upcoming release.
Dest Address
192.168.x.y
(192.168.0.6)
The IP address that the encoder is streaming to.
Dest Port
0 – 9999 (
5004
)
The port that the encoder is streaming to.
Aux TS File Enable
(UDP Only)
True
False
For UDP streaming only. If UDP is being streamed,
this allows the same UDP stream to be saved to a
ts file. The name of the file is specified in “Aux
TS File Location.”
Aux TS File Location
(UDP Only)
/tmp/aux1.ts
Appears if “Aux TS File Enable” is set to “True.”
Specifies where to save the TS file. For example,
if a USB drive is connected, the value
“/media/sda1/example.ts” could be specified.
Video PID (UDP Only)
0 – 8191 (
220
)
PID assigned to video in the TS stream.
PCR PID (UDP Only)
0 – 8191 (
520
)
PID assigned to PCR in the TS stream.
PMT PID (UDP Only)
0 – 8191 (
31
)
PID assigned to PMT in the TS stream.
TS Rate (UDP Only)
125K – 20000K (
8000K
)
The rate of the transport stream. Normally, this
value should be set to 1.25 * (video bit rate +
audio bit rate). This can be set to higher values to
allow leeway for times when many bits are needed
to encode. This can be especially useful for
ensuring smooth playback at lower bit rates (see
Section 6.8, “Adjusting the UDP TS Rate,” on page
20).
Authentication
(RTMP only)
Disable
Enable
When in RTMP mode, the Z3-MVPR-02 supports
entering an authentication User name and
Password. If this is desired, set Authentication to
“Enable”. A “User” and “Password” text box then
appears. The user then enters the appropriate
