4
3-1 Battery Check Command
The users can also enquire the battery status of the unit by sending
BATTERY_GET command via Z-Wave Controller. Once the unit receives the
command, it will return BATTERY_REPORT command. The unit will send
Battery_Level = 255 (0xFF) command to the Z-Wave Controller to inform that
the unit is in low battery status.
BATTERY REPORT Command:
[Command Class Battery, Battery Report, Battery Level = 20%-100%]
3-2 Wakeup Command Class
The unit stays in sleep status for the majority of time in order to conserve
battery power. However, it can be woken up at specified intervals by setting
WAKE_UP_INTERVAL_SET command by Z-Wave Controller. After the unit
wakes up, it will send Wakeup Notification Command to the node ID that
requires to be reported and stay awake for 5 seconds if no
WAKE_UP_NO_MORE_INFORMATION command is received. The minimum
and maximum wakeup interval is 60 seconds and 194 days respectively.
Allowable interval among each wakeup interval is 1 second, such as 60, 61,
62 ….
Note:
The default value is 1 hour, which implies that the detector awakes and sends
the Wakeup Notification Command to the set node every hour.
4. Factory Default Setting
Command Default
setting
Basic Set level
99
Period of Wake Up Notification
1 hour
5. Command Classes
The Flood Detector supports Command Classes including…
*COMMAND_CLASS_SENSOR_BINARY
*COMMAND_CLASS_BASIC
*COMMAND_CLASS_CONFIGURATION
*COMMAND_CLASS_WAKE_UP_V2
*COMMAND_CLASS_MANUFACTURER_SPECIFIC
*COMMAND_CLASS_VERSION
*COMMAND_CLASS_ASSOCIATION_V2
*COMMAND_CLASS_BATTERY
Troubleshooting
Symptom Possible
Cause
Recommendation
Included a node ID
allocated by other
Z-Wave Controller.
Exclude a node ID then
carry out inclusion and
association with new
Controller.
Cannot carry out
inclusion and association
Does not fit batteries or
run out of battery power.
Check if batteries are
fitted or replace a new
battery.
Does not fit batteries or
run out of battery power.
Check if batteries are
fitted or replace a new
battery.
LED not illuminating and
not working
Break down
Send it for repair and do
not open up the unit.
Specifications
Battery
1.5V AAA size x 3
Range
Up to 100 feet line of sight
Frequency Range
908.42 MHz (US) / 868.42 MHz (EU)
*Specifications are subject to change without notice
A501110873R03
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does
