rdq-6 instruction manual
z-systems audio laboratories
4
7.
Control knobs. The three large knobs on the front panel are used to change parameters
shown in the display. All three knobs may not always be active. To aid in understanding
this, the illustrations in this manual will have the knobs "greyed out" when they are not
active in a particular mode of operation.
8.
Volume control button. Pressing this button puts the rdq-6 into a mode where either
the main volume or the individual channel volume offsets can be controlled.
9.
Channel selection button. Pressing this button toggles the display and knobs between
the available channels. When a new channel is chosen, the display will show all of the
filter parameters for that channel.
10.
Infra-red remote sensor.
•
rear panel layout
The only audio connectors visible on the rdq-6's rear panel are three sets of XLR AES/EBU
digital inputs and outputs and three sets of RCA S/PDIF digital inputs and outputs. The main
power switch and the AC mains connector are also located on the rear panel. This is shown
in Figure 3.
F
IGURE
3
1.
Left/Right Front (Left/Right Room Eq 1) digital processor card.
2.
Left/Right Surround (Left/Right Room Eq 2) digital processor card.
3.
Center/Sub (Left/Right TTC) digital processor card.
4.
S/PDIF digital outputs on RCA connectors.
5.
AES/EBU digital outputs on XLR connectors.
6.
S/PDIF digital inputs on RCA connectors.
7.
AES/EBU digital inputs on XLR connectors.
8.
Automation port.
9.
AC power inlet module.
10.
MAINS power switch.
