YZ Systems DynaPak DP-2010TP, Руководство по эксплуатации системы

Страница: 38 / 66

YZ Systems, Inc. • 3101 Pollok Drive • Conroe, Texas • USA • 77303 • P: 936.788.5593 • F: 936.788.5720
Page 32 DP-2010 TP ver.10012004
S
ECTION
9: S
YSTEM
O
PERATION
Preparing The System for Operation
(Electric Heater)
11. Remove the explosion proof enclosure cover
from the heater thermostat housing located
on the outside rear of your sampler.
IMPORTANT NOTE:
Always use extreme care when performing
maintenance on or when making electrical
connections to your sampling system. Always
take the necessary measures to assure that
electrical classifications in the area are consid-
ered, before, and during all repairs, or installa-
tions, and that necessary steps are taken to
maintain proper electrical procedures for the
classification of that area.
12. Connect the conduit, pack-off, etc to the
right side of the thermostat enclosure .
13. Connect the white lead of the incoming
120 VAC power supply wiring to the loose
white lead inside the thermostat enclosure.
14. Connect the black lead of the incoming
120 VAC power supply wiring to the right
terminal on the thermostat. It should have
no other wires connected to it.
15. Connect the green (ground) lead of the
incoming 120 VAC power supply wiring to
the ground connection terminal screw
located inside of the thermostat enclosure.
16. Adjust the thermostat to the desired
temperature.
17. Periodically monitor the temperature
indicated on the outside temperature gauge
while the sample is closed and operation to
assure that your desired temperature is
being maintained. Occasional thermostat
adjustment may be required to find a setting
that is acceptable for varying ambient
conditions.
12.
13.
14.
15.