Revised 26/05/10
ALLURE ELECTRONIC Install Ops May2010
Page 9 of 23
CONNECTION TO GAS SUPPLY AND TESTING PRESSURES
ELECTRICAL:
The unit is connected to the mains supply (240 50Hz 0.5Amp) via the 3m flex with three-pin plug.
GAS SUPPLY:
Burn only the fuel for which the appliance is equipped. The data plate affixed to the base of the appliance
specifies the gas type, which the appliance is factory equipped for.
CONNECTION:
The gas inlet is a Titon 45° 3/8” Tube (
LPG
) or a Titon 45° 1/2” tube (
NATURAL
GAS
)
(Nut Supplied for Connection)
A separate gas isolation valve should be installed immediately up stream of the connection to the
appliance.
Important:
Gas Pipe sizing:
The supply pipe size should be determined from NZS 5261 to ensure
correct gas supply to the appliance. Incorrect pipe sizing
WILL
affect the performance of this appliance.
WARNING:
To stop pipe compounds entering the gas line,
do not
apply sealing compounds to the
first two threads at the tip of any gas connection. All joints should be tested for leaks before operating the
fire.
Gas pressure requirements:
Correct gas pressure and the use of a properly sized gas supply line are essential for the safe and efficient
performance of this appliance. The inlet and outlet pressures at the control must be tested on installation.
Note: Improper gas pressure will affect heater performance, flame Colour or cause pilot malfunction.
Natural Gas:
Input
930:
53 MJ,
730:
50 MJ,
630:
35 MJ
Minimum inlet pressure
1.25 kPa (5"w.g.)
Maximum inlet pressure
5.0 kPa (20"w.g.)
Max Manifold Operating pressure 0.6 kPa with Burners on HIGH
0.25 kPa with Burners on LOW
LPG:
Input
930 & 730:
48 MJ
630:
35 MJ
Minimum inlet pressure
2.75 kPa (11"w.g.)
Maximum inlet pressure
3.5 kPa (14"w.g.)
Max Manifold Operating pressure 1.5 kPa with Burners on HIGH
0.7 kPa with Burners on LOW
CAUTION: Do not use this appliance if any part has been water damaged or exposed to
moisture causing corrosion.
A Qualified service technician should inspect the appliance and replace any part of the
gas system that has been water damaged.
