Revised 26/05/10
ALLURE ELECTRONIC Install Ops May2010
Page 16 of 23
COMMISSIONING
When installed the installer should operate the
YUNCA ALLURE
to ensure that all features are
operating correctly.
Eg. On / Off operation, ramp up and down of fan speed and flame height. Refer below.
Turning on your YUNCA ELECTRONIC ALLURE
1. Turn the Gas and Power supply on.
2. Press the
On / Off
button
once. LED will light up on the front of the base.
3. The burners will light at the same setting and fan speed as they were when previously turned
off.
4. Adjust the
Flame height
button as required to achieve the required heat output.
5. Adjust
Fan speed
button to achieve the optimum speed.
Turning off
(immediate, no timer delay).
1. Press
On / Off
button
once.
Turning off
(using timer delay).
2. Press the
“Off (delayed)” button
once.
3. The Receiver will flash to indicate the timer delay activated.
4. The fire will shut down after 30 minutes.
5. To restart, follow the start procedure.
Fig 8:
Hand Control
Direct the infra-red beam from this hand control to the receiver mounted at
the Control front. The receiver will “light up” when receiving a signal from the
hand control.
The hand control operates on 4 AAA size alkaline batteries. Remove the
battery cover on the back of the hand control to insert batteries paying
attention to the polarity.
Note: multiple pushes of any button(s) may cause a lock out in the
electronics.
If this happens turn the power supply off and back on, then restart
the Gas fire.
Pressing the
On / Off
button
once will initiate the lighting sequence. The
Receiver will light up. The lighting sequence will take approximately 30
seconds and a faint clicking may be heard as sparking takes place.
Pressing the
On / Off button
a second time will turn off the fire.
Flame height
(heat output) is increased by pressing on the + sign of flame
button and reduced by pressing the – sign of the flame button.
Fan speed
is increased by pressing on the + sign of fan button and reduced
by pressing on the – sign of the fan button.
Pressing
Off (Delayed)
will initiate a 30-minute timer delay off.
This can be cancelled by re-pressing the
Off (Delayed)
button.
