Revised 27/05/10
ALLURE Outdoor Install May2010
Page 9 of 17
REMOVING PANELS
1) GRATE
Lift up and out.
2) HEARTH
Lift up and out.
3) FASCIA FRONT
Remove four side screws, two are just in from the
sides at the top, and two at the bottom. Lift the
fascia up slightly and pull forward.
3a) BOTTOM FASCIA STRIP
(Not shown) This part may be fitted along the base
of a regular three-sided fascia (shown above) to
give a “picture frame” effect. When the fascia front
is removed you will see where the bottom strip is
fitted using two screws.
4) TOP LOUVRE #1 (Top)
Slides out for easier access to the top front cowl and
flue spigot – refer 7. May be left in place if access to
the flue spigot is not required.
5) TOP LOUVRE #2 (Bottom)
Remove two screws and slide off. May be left in place
if work is not being carried out on the top cowl or flue
spigot.
6) BOTTOM CONTROL AND GRILL
Remove two screws from the long tabs and tilt
forward slightly to pull out over the control knob. The
control knob can be removed (pull) if necessary.
7) COWL TOP FRONT
Removing the cowl top front gives access to the flue
spigot (visible when fascia is removed).
Remove two screws and slide out.
1
2
3
4
5
7
3
3
3
7
6
