On the basis of the Set Temperature, when the temperature become higher
than Setting Value, the AL-H function is operated.
■
When key is held for 3 seconds, AL-H is displayed on PV, and the
High Limit Value for AL-H is displayed on SV.
■
The value can be set through 00~99 by using , key, and the
Initial Value is set as 50 at the factory.
■
To save as Set Value, press and keys together.
TEMPERATURE CONTROLLER
8
USER
’
S MANUAL
9
On the basis of the set temperature, when the temperature is lower than the
Low Limit Setting Value, the AL-L function is operated.
■
For the first push key for 3seconds, then press the key once again.
■
AL-L will be displayed on PV, and the Setting Value for the AL-L will be
displayed on SV.
■
The value can be set through -99~00, by using , key,
and the Initial Value is set as -50 at the factory.
■
To save as Set Value, press and keys together.
Ex) In case SV(Temperature Setting) is set as 200¡C, AL-H(High Limit
Alarm) as 50¡C, AL-L(Lowest Limit Alarm) as -50¡C :
=>AL-H start at 250¡C of measured temperature, AL-L at 150¡C
■
Output power is reduced to maintain at the STAND-BY Temperature.
■
STAND-BY Mode will finish after the given time, and move into AUTO
Mode
User
’
s can adjust Power Output by using and key for
Emergency Manual Operation at his will.
■
When key is pressed twice, for 1 seconds each at the Auto Mode, it
turns into Manual mode
■
If sensor detect any Disconnection of Thermocouple (tC.oP), or
Thermocouple Short (tC.St), it is converted into Manual mode
automatically for a emergency operation mode.
■
Setting Value(%) can be modified with , keys.
■
Press key for 3 seconds in order to start User’s setting menu.
■
key is used for selecting functions, key for ON/OFF,
and keys for change parameter.
■
To save as Set Value, press and keys together. But also
Present Valve is replaced automatically as Set Value unless any key is
pressed for 5 seconds.
■
Modifying Set Value must be done under LOCK OFF Mode.
3) MANUAL Mode
1) User's Setting Menu
1-1) AL-H (High Limit Alarm Function)
1-2) AL-L (Low Limit Alarm Function)
User's setting menu diagram
7. Menu Setting
