Yuchai YC20SR, Руководство по эксплуатации

Страница: 80 / 152

71
2) Apply the brakes to the
transport vehicle properly and
put pads under the tires to
ensure that the transport
vehicle does not move.
3) Install a ramp between the
transport vehicle and the
machine and make sure that
both sides of the ramp are on
the same level. The maximum slope of the ramp should not exceed 15 degrees.
Adjust the distance between the ramps to match the center of the tracks.
4) Lock the slewing platform.
5) Align the excavator with the hitch ramp, with the dozer at the rear. For safety,
keep the excavator close to the ramp and slowly climb up the ramp.
ATTENTION: While on the ramp, operate only the travel lever, not any other
lever or pedal.
6) Stop the machine and extend the arm (position B in the diagram) so that the front
part of the excavator tracks tilts down
onto transport vehicle, make sure not to
let the work device touch the body of the
transport vehicle while the machine is
tilted down.
7) Lower the arm and drop the bucket on
the floor, lower the dozer and stop the
machine at the specified position on the
transport vehicle.
WARNING: Before the driver leaves the seat after finishing work or
maneuvering, first pull up the safety locking handle and lift the left
control box to disconnect the pilot oil circuit to avoid malfunctioning
of the machine due to mistakes or unintentional hitting of the lever.
ATTENTION: Select a transport vehicle that matches the weight and