
7
Prepare the Area
Use the provided template to mark the drilling locations.
Thoroughly clean the surface and remove any debris,
coatings, fluids or solid particles to ensure proper
adhesion.
Drill
Use a Ø3mm (1/8”) drill bit for the screw pilot holes and
a Ø19mm (3/4”) drill bit for the cable hole.
Clean the surface again before you continue.
Dry Fit
After the surface is completely clean and dry on both
sides, gently guide the cable through the cable bore
and dry fit the fixture onto the hull.
Make sure that the light fixture fits properly, the holes
are aligned and that the fixture sits flat on the hull
before proceeding to the next steps.
Содержание 03
Страница 1: ...03 I N S T A L L A T I O N G U I D E ...
Страница 2: ......
Страница 15: ...15 Notes ...
Страница 16: ......