8
Attaching the Crib Side
Step 3:
Position (1) Crib Side, as shown in Fig-
ure 7, by aligning the Locater Pin on the
top edge of the Base Rail with the hole
in the bottom rail of the Crib Side.
Gently spread the top of the Crib Ends
to allow the Locater Pins in the Crib
Ends to engage the holes in the ends of
the Crib Side top rail. See Figure 8.
Insert (4)
2”
Connector Bolts into the
holes that are in the end uprights of the
Crib Side. Loosely attach the Crib Side
to the Crib Ends using the provided
wrench. Do not tighten the bolts at this
time. See Figure 9.
Tighten the connector bolts that attach
the Base Rail to the Crib Ends at this
time with the provided wrench. See Fig.
4 on Page 7.
Attach the remaining Base Rail and Lo-
cater Pins following Step 2 on page 7.
Do not completely tighten Base Rail
bolts at this time.
Figure 10 is how your Crib should
look at this point.
Figure 7.
Align Crib Side
Base Rail
Figure 7.
Enlarged View of
Crib Side alignment
Figure 8.
Figure 8.
Enlarged View of
Crib End - Crib Side
alignment
Locater Pin
Crib Side
Crib End
See
Figure 9.
Figure 9.
Enlarged View
Wrench
2” Bolt
Figure 10.
Assembled View
Fig. 8
Fig. 9
