9 |
P a g e
B. Operation
On the first use of remote controller, install the batteries first: open the battery box by sliding its
cover along the arrow, install two AAA batteries according to the marks in the box, and slide the
cover to its original position. If no batteries installed or the batteries are not working, the
remote controller will be unusable.
To use the remote controller effectively, point it to the electric fireplace and keep a distance of
1-5 meters.
There are four buttons marked the same as buttons on the remote controller, each pair of them
perform the same function, choose as you favor.
1.
On/Off Switch
. Press on/off switch to turn fire on. The indicator lamp will brighten
up in the control panel. Press the <ON/OFF> button again; the fireplace will be
powered off.
2.
Flame Effect Dimmer
. Adjust the brightness of simulated flame and logs. When the
fireplace is powered on, flame is turned on automatically. Press <DIMMER> button to
adjust the brightness, the
lamp will be flashing. During the dimming cycle the fire
will slowly dime then brighten allowing user to choose suitable level. Press a second
time to stop cycle when the desired brightness level is obtained.
3.
Fireplace Low Heat
(750 W). Press <LOW> button once to switch the fireplace to low-
power status. The indicator lamp
will brighten up. Press again the <LOW> button to
turn it off.
4.
Fireplace High Heat
(1500 W). Press <HIGH> button once to switch the fireplace to
high-power status. The indicator lamp
will brighten up. Press again the <HIGH>
button will turn it off.
NOTE
Before the fireplace emits heat or after it stops producing heat, the hot air outlet may output
air for 10 seconds. This is designed to protect the circuit.
6. Switch off the fireplace when you leave it for a long time.
7. Remove the two alkaline batteries from the appliance before it is scrapped.
8. The alkaline batteries need to be disposed of safely.
9. Roll up the power cord in the supports when the fireplace is not in use. If you select to
store your fireplace fully assembled, be sure to cover it, to protect it from accumulating dust.
10. Temperature Limiting control will automatically turn the unit off if it reaches a certain
temperature. Unplug the unit. When the temperature falls, the thermostat will be
restored. Connect the plug to power and fireplace will work.
