York Fitness Diamond R301 Rower, Руководство пользователя, Страница: 9 / 24

9
aSSemBLy InStrUCtIonS
StEp 7
Slide the pedal pivot rods through the main frame 1.
holes until an equal amount of the rods protrude
from each side.
Slide the spacers and pedal assemblies onto the 2.
pivot rods from both ends and secure, using 4 x
allen head bolts and washers as shown.
make sure
the two different pivot rods are fitted in the same
order as shown in the diagram and bolts are fully
tightened with allen key.
Part No. 47 x 4
20MM ALLEN HEAD BOLT
Part No. 35 x 4
FLAT WASHER
Part No. 33 x 4
PLASTIC SPACER
StEp 8
Remove the poly-foam block attached underneath 1.
the front end of the main frame.
Loosen the hand wheel knobs and rotate the 2.
console fixing plates to the required view angle.
Re-tighten the hand wheel knobs to fix the plates in 3.
position.
Insert 4 x batteries (AA size 1.5V) into the 4.
compartment in the back of the computer console.
(See page 11 for batteries replacement instructions)
Attach the computer console onto the fixing bracket 5.
and secure, using 4 x machine screws as shown.
(The machine screws are located in the back of the
computer console.
Plug the computer wire into the socket on the back 6.
of the computer through the fixing bracket - make
sure it’s fully connected.
22