Page
16
/
35
Hint: Determine your blood pressure based on each measurement and the blood pressure table, and
consult your doctor.
3) Take off the cuff from your arm and turn off the device by press the User1 “ ” or User2 “ ” button. (If there
is no operation for 60 seconds, the device will be automatically off.)
6.3 Prompt function of irregular heartbeat
This monitor can detect the situation of irregular heartbeat. In the measuring process, if the appearance of this "
" symbol signifies that an irregular heartbeat was detected, it means that the result may deviate from your
normal basal blood pressure. This indicator is only a caution, it is important that you be relaxed, remain still and
do not talk during measurements. Please repeat the measurement.
An irregular heartbeat rhythm is defined as a rhythm that is 25% less or 25% more than the average rhythm
detected while your monitor is measuring blood pressure. If the "
" symbol appears more frequently (e.g.
several times per week on measurements performed daily) or if it suddenly appears more often than usual, we
recommend you to consult with and follow directions of your physician.
Note:
If you have severe arrhythmia, it is very likely that you will not be able to measure the blood pressure.
6.4 Voice broadcast
Broadcast state
Broadcast content
Start measure
Start measuring now
Finish measurement
The result of this measurement is XX, systolic blood pressure is XX, diastolic blood
pressure is XX, and pulse is XX beats per minute, I wish you a good health, thank you
for using
Measurement failure
The measurement failed, please try to wear the cuff and start a new measurement
again
Memory broadcast
Systolic blood pressure was XX, diastolic blood pressure was XX, and pulse was XX
beats per minute, I wish you a good health, thank you for using
Low battery
Low battery
，
Please charging the device soon
Note: XX is the voice content corresponding to the measured actual value.
6.5 Memory Function
6.5.1 Check the measurement records
1) In the shutdown state, press memory button “
” enter memory mode.
Emergency stop!
Stop the measurement in emergency condition:
In the process of measurement, if the subject feels uncomfortable or needs to interrupt the measurement
due to some other reasons, please press the user1/2 button, the machine will stop the measurement
immediately and quickly discharge the air in the cuff to reduce the pressure. If the user1/2 button fails,
please unfasten the cuff and stop the measurement.
