■
35 Gear Ratio
This is to set the gear rate of the vehicle. If this setting is not
done correctly, max speed could be indicated differently.
■
36 Tire Diameter
This is to set the diameter of the tire. If this setting is not
done correctly, max speed could be indicated differently.
■
37 Motor-Wiring
This is to set the order of motor cable connection like
A-B-C or C-B-A. When you need to change this, make
sure to also change the motor con
fi
guration and setting
identically. Otherwise, wrong configuration and setting
could cause the damage to the ESC.
■
38 Units
You can change the unit to display temperature and
speed.
■
39 Download
Changed setting value is stored at the ESC.
■
40 Factory Setting
Changes the ESC setting parameters to the factor y
default settings.
■
41 Current Voltage
You can check the present battery voltage when the
program is connected.
■
42 Current Temp
You can check the present ESC’s temperature when the
program is connected.
■
43 Max Temperature
You can check the max temperature that is obtained
during racing when the program is connected.
■
44 Motor Temp
You can check the present motor’s temperature when the
program is connected
■
45 Motor Max Temp
You can check the max temperature of the motor that is
obtained during racing when the program is connected.
■
46 Max Current
You can check the max current that is obtained during
racing when the program is connected.
■
47 Maximum Speed
This is to con
fi
rm the max speed that is obtained at racing
of the car.
■
48 Maximum RPM
This is to con
fi
rm the max RPM of the motor that is obtained
at racing of the car.
■
49 Error History
(R) signal problem of the receiver.
(V) this is to indicate the ESC stops due to low voltage.
(S) Sensor problem.
(T1) this is to indicate the ESC stops due to the temperature
issue on the ESC.
(M) Motor connection problem / motor problem / product
damage
(T2) this is to indicate the ESC stops due to the temperature
issue on the motor.
10.LED status for the error
■
RED LED blinks one time repeatedly mean that there is no receiver signal. Please check the connection part of
transmitter/receiver.
■
RED LED blinks two times repeatedly mean that low voltage cut is activated.
■
RED LED blinks three times repeatedly mean that motor sensor has a problem. Please check the sensor cable
connection and motor status.
■
RED LED blinks four times repeatedly mean that temperature protection of ESC is activated.
■
RED LED blinks five times repeatedly mean that there is PWM output but the motor isn’t running for more than 2
seconds. Please check the motor status or check the car.
■
RED LED blinks six times repeatedly mean that temperature protection of motor is activated.
11.Data check
You can check the maximum temperature/current/speed/rpm of ESC and MOTOR through a program box or WiFi
module.
When using the program box, the ESC should not be powered off after racing and the program box should be
connected to the connection port to check the data. Data are deleted if the ESC is powered off.
Yokomo Ltd
Address: 5-23-7 Ayase, Adachi-ku Tokyo, 120-005, Japan
Tel : +81-3-5613-7551
Web: http://www.teamyokomo.com
Содержание X Series
Страница 8: ......