YOKOGAWA YPP6300, Инструкция по эксплуатации

Страница: 13 / 100

Model YPP6300 Pulse Input Rate/Totalizer Instruction Manual
13
RELAY RESET User selectable via front panel buttons, digital inputs, or PC
1. Automatic reset only (non-latching), when the
input passes the reset point or total is reset to
zero.
2. Aut manual reset at any time (non-latching)
3. Manual reset only, at any time (latching)
4. Manual reset only after alarm condition has cleared
(L)
Note: Front panel button or digital input may be assigned to
acknowledge relays programmed for manual reset.
TIME DELAY 0 to 999.9 seconds, on & off relay time delays
Programmable and independent for each relay.
FAIL-SAFE
OPERATION Programmable and independent for each relay.
Note: Relay coil is energized in non-alarm condition.
In case of power failure, relay will go to alarm state.
AUTO
INITIALIZATION When power is applied to the meter, relays will reflect the
state of the input to the meter.
Isolated 4-20 mA Transmitter Output
OUTPUT
SOURCE Rate/process, total, grand total, max, min, set points 1-8,
Modbus input or manual control mode
SCALING RANGE 1.000 to 23.000 mA for any display range.
CALIBRATION Factory calibrated: 0.0 to 1000.0 = 4-20 mA output
ANALOG OUT
PROGRAMMING 23.000 mA maximum for all parameters:
Overrange, underrange, max, min, and break
ACCURACY ± 0.1% FS ± 0.004 mA
TEMPERATURE
DRIFT
0.4 µA/

C max from 0 to 65

C ambient,
0.8 µA/

C max from -40 to 0

C ambient
Note: Analog output drift is separate from input drift.
ISOLATED
TRANSMITTER
POWER SUPPLY
Terminals I+ & R: 24 VDC

10% @ 40 mA maximum; may
be used to power the 4-20 mA output or other devices.
Refer to Figure 6 on page 21 and Figure 14 on page 26.
EXTERNAL LOOP
POWER SUPPLY 35 VDC maximum
OUTPUT LOOP
RESISTANCE
Power supply Minimum Maximum
24 VDC
10

700

35 VDC (external)
100

1200
