2-7
IM 04P03B01-01E
Frequently Used Setup Operations (Setting Mode)
2
Square Root Computation
(RANGE)
(CH1)
(SQRT)
(2V)
(ON)
Select “SQRT.”
Select the channel number.
Select from the range types of DC voltage.
20 mV, 60 mV, 200 mV, 2 V, 6 V, 20 V, or 50 V
Set the left span value.
Set the right span value.
Select the right scale value.
Set the low-cut point.
0.0 to 5.0% of the recording span, 0.1 steps.
Select “RANGE.”
(OK)
The settings are activated.
Channel number
Span left
Span right
Scale left
Scale right
(Displays the following when the low-cut
is enabled)
Turn ON or OFF the low-cut function.
Select the left scale value and the decimal place.
Low-cut
Decimal point
Description
• Input Type on Which Square Root Computation Can Be Performed
Square root computation can be performed when set to DC voltage input.
• Span Left and Span Right
Same as the selectable span range of the DC voltage range.
Make sure that span left is less than span right.
• Scale Left, Scale Right, and Decimal Place
Selectable range (mantissa): –19999 to 30000
Example: The value in the range of –100.00 to 350.00 cannot be specified. The
mantissa of scale right is 35000, which exceeds the upper limit to 30000.
Set in the range of –100.0 to 350.0.
Decimal place:
XXXXX, XXXX.X, XXX.XX, XX.XXX, X.XXXX
To set the decimal place for the left scale setup item, press the
key to make
blink, then press the
or
key.
The decimal position is the position specified by scale left.
Make sure that scale left is less than scale right.
2.1 Setting the Input Range
