ENGLISH
２８
MAKE CAPPUCCINO
You can get a cup of cappuccino by topping a cup of espresso with frothing milk.
Note:
during making steam, the metal funnel must be assembled in position.
Method:
1. Prepare espresso first with container big enough acco
rding to the part “MAKE ESPRESSO”, and make
sure that the steam knob is at the
“O” position.
2. Press
and wait until the steam indicator stops blinking.
3. Fill a jug with about 100 milliliters of milk for each cappuccino to be prepared, you are recommended to
use whole milk at refrigerator temperature (not hot!).
4. In order to get better milk foam performance, you are recommended to keep steam knob at open
position for approx 15s , since the early steam contains too much water.
5. Insert the steam wand into the milk about two centimeters, then turn the steam knob slowly in
anticlockwise to
position, steam will come out from the steam wand. Frothed milk is produced
by moving vessel round from up to down.
Note:
Never touch steam outlet during steam jetting and be careful not to burnt.
Note
: Never turn the steam knob rapidly, as the steam will accumulate rapidly in short time which may
increase the potential of the risk of explosion.
6. When the required purpose is reached, set the steam knob at
“O” position. Press
again.
7. Press
to turn the device off.
8. Pour the frothed milk into the espresso prepared, now the cappuccino is ready. Sweeten if desired,
sprinkle the froth with a little cocoa powder.
WARNING:
•
To avoid clogging of the steam nozzle after frothing follow these instructions: place an empty cup under
the frother and wait until the heating indicator turns blue. Twist slowly the steam knob to
position and water will start coming out of the frother nozzle. After about 30 seconds, set the knob at
the
“O” position. Take off the plastic cover by pulling it downwards. Wipe the frother with a damp
sponge. Be careful not to burn yourself.
•
To clean the unit after preparing coffee follow these instructions: Unplug the device. Some metal parts
may still be hot, do not touch them until they have cooled down. Wash the porta-filter and filter using
warm water with dish soap, rinse it carefully and dry off. Do not wash in a dishwasher. Wipe coffee
remains off the upper part of the head. You may use a damp cloth or a paper towel. Place portafilter
(without a filter installed) in the head. Place a cup under porta-filter nozzles. Turn on the device, and
then wait until the heating indicator turns blue. Make sure that the one cup indicator is no longer
