7. OPERATION
104
7.8.6.1 Position :
The value shown here indicates the current position of the machine.
7.8.6.2 Positioning Offset :
It indicates the position of the machine on the zero point. It is
used during calibration of the machine. Calibration procedure is explained separately.
7.8.6.3 Saw Thickness :
The tooth thickness of the saw installed to the machine is written
here.
7.8.6.4 Saw Run-Out Value :
If the saw installed on the machine causes run-out in the
course of time, + or - values can be entered here to indicate the tolerance.
7.8.6.5
Serial Cut Fire Share :
When slicing in serial cutting mode, If you want to clean a
little more in the head the can enter required value here.
7.8.6.6 Com Port :
Number of the port where the barcode printer is connected is entered
here.
7.8.6.7 Font :
It is intended only for reading purposes; no modifications are allowed.
7.8.6.8 Com Port On Off :
Turns the port on or off where the barcode printer is connected.
No barcodes can be printed when it is turned off. If necessary, USB can be plugged and
this port can be turned off and the printer can be operated by means of the USB. Com
port is used as factory setting.
7.8.6.9 mm / inch adjustment:
To make the dimensions in inches, click on
button
on this page and switch to the
mode. To do this, the password must be entered
first. By pressing
button enteren
1234
password and the button is
activated.
Should the servo drives switch to alarm mode, the drives are reset by pressing this
button.
It opens the page where factory settings are made. Access requires password and
it is used by service personnel.
The machine will be moved to the reference point when this button is pressed.
It opens the page where angle offset settings are made. Password is required for
that. Required password is
( 1234 )
Содержание DC 550
Страница 1: ...www yilmazmachine com tr ...
Страница 61: ...7 OPERASYON 60 ...
Страница 118: ...7 OPERATION 117 ...
Страница 175: ...7 ОПЕРАЦИЯ 174 ...