Yeti SB135/LR, Руководство пользователя

Страница: 10 / 24

SB135 | OWNER’S MANUAL
10
09
Apply grease to main pivot cavities of Rear
Triangle. Slide Rear Triangle Assembly onto
main pivot and secure with Main Pivot Collet
Axle (3.1) and Routing Collet Nut* (3.7), placing
routing feature at the top. Apply Loctite to the
threads and grease shaft of the Pivot Collet
Axle (3.1).
Torque:
25 Nm
*Needs a plain collet nut (3.2, flat top with no
clamp feature) if kit uses a wireless drivetrain.
07
Lightly grease and place 2x Race Extenders
(3.3) onto the lower bearings in Link Assembly
(3.16). Install into front triangle using Link Pivot
Collet Axle (3.5) and plain Collet Nut (3.2). Apply
Loctite to the threads and grease the shaft of
the Pivot Collet Axle (3.5). Apply grease to the
Link pivot cavitites.
Torque:
25 Nm
08
Assemble Upper (3.23) and Lower (3.22) Shock Extender to SB135 Link (3.16 or 3.41) by placing 2X Race
Extender (3.15) in the extender cavities and sliding between the Link tabs. Threaded Extender (3.23)
should be oriented to the top. Secure with a Guide Pin and assemble Female 8x41mm Bolt (3.17) with
Washer (3.21) through the assembly. Apply Loctite to the threads and secure with Male M6 Bolt (3.19)
and Washer (3.20).
Torque:
10 Nm
QC CHECK
Cycle rear triangle through to make sure motion
is smooth.
Take precaution to make sure link does not
contact seat tube.
10
Lightly grease and place 2x Race Extenders (3.3) onto the upper bearings in Link Assembly (3.16 or 3.41).
Rotate Rear Triangle and Link together, lining up SS Pivot bores.
Apply Loctite to the threads and grease shaft and underneath the head of the SS Pivot Screws (3.4).
Install 2x SS Pivot Screws (3.4) from the inside of the Link and partially into the Rear Triangle.
Apply grease to SS pivot cavities and place 2x plain Collet Nut (3.2) into the Rear Triangle.
Using a wrench from the outside of the Swingarm, begin tightening in the “left-hand” direction (this is
still a standard thread, but installed from the inside), tightening the SS Pivot Screw and Collet Nut.
Torque:
25 Nm
11
Grease wedge and threads. Install Large Collet
Wedge Bolts (3.9) into 2x Collet Axles (3.1)
and (3.4).
Torque:
14 Nm