Yeti 160E, Руководство пользователя

Страница: 8 / 25

YETI 160E | OWNER’S MANUAL 8
MAINTENANCE
TABLE OF CONTENTS |
KEEP YOUR YETI
FRESH AND CLEAN
MAINTENANCE OVERVIEW
Following these guidelines will help maintain the performance of your bicycle and prevent
more serious problems from arising. It is important to remember that service intervals can
vary depending on climate, trail conditions and riding frequency. Servicing your bike requires
special knowledge and tools. If you are unsure about working on your own bicycle, contact your
authorized Yeti Dealer for more information on general bicycle maintenance.
This owner’s manual should be used in addition to the manuals supplied with you bike by the
component manufacturers. If those manuals are missing, most component manuals can be found
on the component manufacturers website or contact your local dealer.
Any component of the SHIMANO STEPS system should only be serviced by a certified mechanic.
All STEPS related service should be taken to a Yeti authorized dealer and not attempted by the user.
Before any maintenance is performed be sure
to turn off the E drive system and remove battery.
TORQUE
Yeti strongly recommends using a torque wrench when assembling your frame. Torque
specifications for individual parts on the 160E are listed below, as well as in the step by step
assembly instructions later in the manual. For general bicycle maintenance please consult the
torque specifications of the component you are adjusting.
SCHEDULE
BE
FO
R
E
EAC
H
R
ID
E
M
O
NTH
LY
3 M
O
NTH
S
A
NNU
A
LL
Y
Clean and lube chain
•
Check tire pressure
•
Clean bike of mud and debris
•
Check brake function
•
Ensure all cable ends are covered with crimped cable end caps
•
Check rims for deformations or cracks
•
Check shock pressure
•
Check for loose bolts and tighten, if necessary
•
Check headset and tighten/loosen, if necessary
•
Check for firmware updates using e-tube app
•
Thuroughly clean pivot points with a rag (do not lubricate)
•
Check / replace brake pads
•
Check tires for wear
•
Check spoke tension, retention, if necessary
•
Check chain for wear, replace if necessary
•
Complete tune-up performed by an authorized Yeti Dealer
•
KEY TORQUE SPECS
ITEM # DESCRIPTION TORQUE (NM)
4.8 Main pivot axle
20
4.14 Clevis pivot bolt, M12
12
4.42 Collet axle, 10mm long head
12
4.9 Collet wedge bolt, large
14
4.12 Link, pivot hardware, male, 15MM
15
4.36 Universal derailleur hanger
25
4.21 Motor mount screw, M8 BHCS
12
4.44 Collet wedge bolt, small
8
4.11 Shock bolt, M10
12
4.59 Tie link bolt, long
12
4.10 Tie link bolt, short
12