Yeti 160E, Руководство пользователя

Страница: 7 / 25

YETI 160E | OWNER’S MANUAL 7
SETUP
TABLE OF CONTENTS |
TURNING ON/OFF THE SYSTEM
− Push down power button on the toptube and hold briefly to turn on or off the system.
− The battery must be charged for system to turn on.
− Power cannot be turned on while the battery is charging.
− If the bike has not moved for 10 minutes, the power will shut off automatically.
− Ensure the bike is stationary prior to powering on the system.
MODE SELECTION
− The support mode can be selected using the mode switch on the left side of the
handlebars once the power has been turned on.
− Toggle between the 4 modes, Off, Eco, Trail and Boost, by pushing the up or down
buttons on the mode switch. The direction of mode selection can be customized in the
Shimano E-Tube app.
− To activate Walk mode, push and hold the button that decreases the support until walk
mode appears on the display. The bike must be stationary in order to enter walk mode.
Release and push and hold again to start the walk assist.
− Walk support will only be active when the button is pushed and held.
− Further mode switch operation information can be found in the Shimano mode switch
user manual included with you bike or inline at https://www.shimano-steps.com/
DISPLAY OPERATION
− See Shimano STEPS user manual provided with your bike or at the Shimano STEPS
website, https://www.shimano-steps.com/, for operation instructions.
E-TUBE PROJECT
− System updates and system customization is all available through the Shimano E-Tube
app.
− Download the E-Tune app on your phone and enable Bluetooth to connect to your bike.
− Follow the E-Tube app instructions on the Steps website for connection, updates and
customization guidance.
− For more information go to the Shimano E-Tube website, https://bike.shimano.com/
BATTERY REMOVAL AND INSTALLATION
− To remove the battery, insert a M4 allen wrench into the small hole at the top of the
battery guard.
WARNING: Do not remove the collet bolt or axle that is on the non drive side of the down tube
near the head tube.
− Ensure the wrench is secure in the latch bolt head and turn clockwise ¼ turn until the
battery releases and falls onto the secondary catch.
− Supporting the battery with your hands, insert your finger between the frame and the
battery cover and depress the catch to release the battery fully.
− Lower the top of the battery down and then pull the battery out from the lower mount.
− To reinstall the battery, insert the bottom of the battery into the lower mount in the frame.
− Ensure the lower mount is properly seated then press the upper part of the battery into
the top mount until you hear 2 clicks.
− Double check that the battery is fully secured, and it is not resting on the secondary catch.
SETUP CONTINUED
INITIAL SETUP SHOULD BE PERFORMED BY A CERTIFIED
MECHANIC PRIOR TO MAKING ADJUSTMENTS OR FIRST USE.