28
Assembly Cont.
assembly
frame assembly
lube the Main pivot pin (M6 X 17 X 67.5 mm) with
a lithium or ploylube grease.
frame assembly
slide the swingarm into position over the main
pivot mount above the bottom bracket. line up the inner race of the
bearing with the thru hole on the main pivot.
slide the Main pivot pin (M6 X 17 X 67.5 mm) into the bearing and tap
through the frame with a dead blow hammer. there may be some
resistance as you tap the pin through, this is normal. tap the pin until it sits
flush against the bearing face,
frame assembly
slide the Main pivot Washer onto the Button Head
Bolt (M6 X 1 X 12 mm). apply a small amount of blue loctite to the
threads and thread into the Main pivot pin.
19
frame assembly
place a 5mm allen key on the Button Head bolt
and a 6mm allen key into the main pivot pin and secure.
torque spec: 125-150 inch pounds.
20
frame assembly
rotate the swingarm into position over the end
of the shortlink. slide the Guide pin through the seatstay mount as
shown.
slide the Washer (8.5 X 12.5 X 0.5 mm) onto the Female Yeti Bolt 43mm.
then attach the bolt and washer to the stepped end of the Guide pin.
frame assembly
tap the end of the bolt with a dead blow hammer
to slide the bolt through the seatstay mount and shortlink.
frame assembly
attache the
Male pivot Bolt 17mm and
Washer (8.5
X 12.5 X 0.5 mm) onto the female bolt. Make sure to apply a small
amount of blue loctite to the threads.
torque spec: 125-150 inch pounds.
23
frame assembly
the last step is to attach the derailleur hanger.
place a small amount of blue loctite on the threads of the derailleur
hanger bolts and secure with a 2.5mm allen key.
24
21
22
17
18
