setup
for MIG (GMAW) & Flux-cored
Wire (FCAW) Welding
• Connect the work clamp to the appropriate DINSE SOCKET
-Flux-cored
wire welding
(FCAW): Work clamp to POSITIVE
SOCKET.
-MIG Welding
(GMAW): Work clamp to NEGATIVE
SOCKET.
• Ensure the work clamp has a good connection
to the workpiece and is connected
on clean, bare metal (not rusty or
painted)
• Load the spool of wire inside the cabinet and feed it through the WIRE FEEDER into the gun (see "Installing the Welding
Wire", page 1().
• (GMAW only) Connect the gas line to the regulator and connect to the gas cylinder
• Turn the power source on and select the MIG/MAG function with the Process Selection Button
• Press the gun trigger to load the wire through the gun.
• (GMAW only) Turn on the gas cylinder, pull the trigger to check for gas flow and set the flow rate to between 20—30 CFH.
• Press
material
selection
button
to choose
C02
100%,
Mixed
Gas, Gasless
• Select
the wire diameter
• Set torch operation 2T/4T
-2T Mode: Press the gun/torch
trigger
to weld and release to stop.
-4T Mode:
Press and release the gun/torch
trigger
to start,
weld without
holding
the trigger
on and stop by
pressing
and releasing
the trigger again. This is particularly
useful when doing long weld runs.
• Press the Button to choose
Manual/
Smart Mode and rotate the value
adjustment
knob (1 and 2) to change the
parameters as below
• Trigger the torch control switch to feed wire and start welding
How
To Choose
Smart
MIG
Smart MIG this is a predefined setting based on Gas and wire used. The machine will preselect voltage and amperage allowing the
user to quickly find the best welding parameters
Simply select the correct wire diameter and gas type that you're using then dial in your desired wire feed speed for the job. Use
more wire speed for thicker material and less wire speed for thinner material. The Smart MIG system will auto-adjust the welding
voltage to give you an ideal arc condition while welding
1 . Press
the Smart
/ Manual
Selection
Button to choose
Smart
Mode
2 Select the weld spec
3. Adjust the Amp / WFS Adjustment (2) to change the output amperage, the wire feeding speed will automatically changed
4. Adjust the Voltage Adjustment (1) to fine-adjust the voltage from -5-5V.
Details for Setting for Smart MIG
40-120
40-120
40-120
40-120
40-120
40-120
40-160
40-160
40-160
40-160
40-160
40-160
Mode:
Ilov
220V
Torch
Mode
Material
ss
ss
Fe Mix
Fe
Mix
Fe coa
Fe C02
Material
ss
ss
Fe Mix
Fe
Mix
Fe C02
Fe COZ
Weld
Spec
size
0.8mm,'
030"
0 9mm/
035"
0.8mm/.030"
0.9mm/
035"
0.8mm/
030"
0 9mm/
035"
size
0 8mm/
030"
0.9mm/
035"
0.8mm/.030"
0 9mm/
035"
0.8mm/
030"
0.9mm/
035"
• 14
Value
Amp
Amp