MyPBX U500 Installation Guide
http://www.yeastar.com 12/13
just configuring the IP address of the LAN port which is connected to the local area network of the company
is OK.
WAN Settings
Click “Network Settings”->”WAN Settings” on the left menu bar.
1.
If the network that the WAN port is connected to is using DHCP server as connection method, please
select the “DHCP” (dynamic IP) option.
2.
If the network connection method is “Static IP address”, please select this option and enter the LAN
parameters (IP address, subnet mask, default gateway, DNS, etc.)
3.
If MyPBX is connected to ADSL adapter directly, please select “PPPoE” option and enter the ADSL
user name and password.
LAN Settings
Click “Network Settings”->”LAN Settings” on the left menu bar of the web configuration interface. LAN
port is used for the interoperability of IP terminals and MyPBX. If the LAN port is connected to the
company’s LAN, please configure the correct IP address and corresponding subnet mask.
Please note that after changing the IP address of LAN port, MyPBX should be rebooted to make the new
changes take effect.
4.4 Extensions Setup and management
MyPBX has already set up 6 extensions by defaults which are extension”300-305”. The password is “pincode
+ extension number”. It’s up to the user to use these default extensions directly or after changing the
password. Of course, they could be deleted.
The admin could add, edit or delete the extensions via the Web Configuration Panel.
In the “Extensions” page, there are “Add Extension”, “Add Bulk Extensions”, “Delete the Selected Extension”
and “Edit Extension”(configure the features such as call forwarding and voicemail) subpages, etc.
4.5 Configuring Terminals
MyPBX could be connected with SIP-based audio and video IP terminal devices (e.g. IP Phone, voice gateway,
and soft terminal, etc.). The steps of configuring terminals are as below:
Step 1: Make sure the IP terminal and MyPBX are interconnected
Step 2: Enter the IP address of MyPBX when configuring “SIP server”, “Proxy server”, or “Registration server”
of the IP terminals, and the default SIP UDP port is 5060.
Step 3: Enter the account registration information with the “extension number/password” of the default or
newly setup extensions of MyPBX.
For more information on terminal configuration, please refer to
http://www.yeastar.com/Solutions/SIP_Phones.asp
Step 4: Reboot the IP terminal after configuration, and click “Status Monitor”->”Line Status” on the menu bar
of MyPBX web configuration interface to check if it has registered successfully to MyPBX.
