Yealink VC Series, Руководство администратора

Страница: 45 / 180

Configuring Network
35
2. Uncheck the DHCP checkbox.
3. Enter the preferred values in the IP Address, Subnet Mask, Gateway, DNS Primary
Server and DNS Secondary Server fields respectively.
4. Press the Save soft key to accept the change.
The display device prompts ―Reboot now?‖.
5. Select OK to reboot the system immediately.
Note
You can configure the network speed and duplex mode the system uses. The network
speed and duplex mode you select for the system must be supported by the switch. The
duplex modes supported by the system are: Auto, Half Duplex and Full Duplex. The
network speeds supported by the system are: 10 Mbps, 100 Mbps and 1000 Mbps.
Available that can be configured for the system are:

Auto

10 Mbps Half Duplex

100 Mbps Half Duplex

10 Mbps Full Duplex

100 Mbps Full Duplex

1000 Mbps Full Duplex
Auto is configured on the system by default.
Auto
Auto means that the switch will negotiate the network speed and duplex mode for the
systems to transmit voice or data over Ethernet. This process entails devices first sharing
transmission capabilities and then selecting the highest performance transmission
mode supported by both systems.
Half-duplex
Half-duplex transmission refers to transmitting voice or data in both directions, but in
one direction at a time; this means one system can send data on the line, but not
receive data simultaneously.
Full-duplex
Full-duplex transmission refers to transmitting voice or data in both directions at the
Wrong network settings may result in inaccessibility for your system and may also have
an impact on your network performance. For more information on these parameters,
contact your system administrator.