YATO YT-84905, Руководство пользователя

Страница: 17 / 96

17
O R I G I N A L I N S T R U C T I O N S
GB
1. PROPERTIES OF THE PRODUCT
The purpose of the chain sawing machine is to be used in household tasks. The sawing machine is meant exclusively to cut wood.
Since the sawing machine is equipped with a combustion engine, it must be operated in open areas or in adequately prepared
interiors. The sawing machine may also be used to fell trees, but due to the danger involved, it is required it is operated by an
experienced user. A correct, reliable and safe functioning of the device depends upon its adequate operation, and therefore:
Before you proceed to use the tool, read the whole manual and keep it.
The supplier shall not be held responsible for any damage and injuries caused by operation of the tool other than intended, failure
to observe safety regulations and recommendations of this manual. Operating of the tool for purposes other than intended shall
also render the warranty void.
2. EQUIPMENT
The sawing machine is delivered complete, but before first operation it requires assembly.
Along with the sawing machine the following elements are supplied:
- chain guide
- cutting chain
- protection of the guide
3. TECHNICAL DATA
Parameter Measurement unit Value
Catalogue number [kg] YT-84905
Weight [cm
3
] 6,0
Fuel tank capacity [cm 3 ] 560
Chain lubrication oil tank capacity [mm] 260
Cutting length [cm] 50
Chain scale [mm] 8,255
Guide link length 1,27
Chain type 20BPX078X (0,325” Oregon)
Chain guide type 200PXBW095 / 200PXBK095, Oregon
Maximum chain speed [m/s] 19,2
Number of sprockets of the chain driving wheel and scale 7 sprockets x 8,255 mm
Motor
Number of cylinders
1
Strokes 2
Cooling air
Type of spark plug L8RTF, BM6A
Motor swept capacity [cm3] 49,3
Motor power [kW] 2,0
Maximum acceptable rotational speed of the motor with the cutting system [min -1 ] 8500
Recommended idle rotational speed [min -1 ] 3000 ± 300
Fuel consumption at the maximum motor power [kg/h] 0,740
Unitary fuel consumption at the maximum motor power [g/kWh] 359
Noise
Acoustic pressure
[dB (A)] 106,5 ± 3
L
wA
power [dB (A)] 114,4 ± 3
Vibration level - front / rear handle [m/s2] 6,9 ± 1,5 / 9,4 ± 1,5
4. GENERAL SAFETY CONDITIONS
WARNING! During operation of a gasoline, it is recommended to always observe the basic safety regulations including those
mentioned below, in order to diminish the risk of fire, electric shock and injury.
Before operation of the tool can be commenced, the whole manual must be read and kept.
ATTENTION! Read all the instructions mentioned below. If they are not observed, there is a risk of electric shock, fire or injury.
The notion of „gasoline tool” that is used in the instructions refers to all tools that are powered with a stream of compressed air
at appropriate pressure.