YATO YT-82280, Руководство пользователя

Страница: 11 / 60

11
GB
O R I G I N A L I N S T R U C T I O N S
PROPERTIES OF THE TOOL
The reciprocating saw is an electric tool designed for cutting of wooden surfaces and surfaces made of wood and those made of
wood derivatives, polyethylene and metals, using adequate blades. Thanks to easy replacement of blades which does not require
additional tools, the saw offers a wide range of applications in building tasks. A correct, reliable and safe operation of the tool
depends on its correct use, so:
Read the operating manual thoroughly before work and keep it for future reference.
The supplier shall not be held responsible for any damage occurred as a result of failure to observe safety regulations and indica-
tions contained in this manual. Using the tool for purposes it has not been designed for will make the guarantee void and cancel
any rights implied by a breach of contract.
ACCESORIES
The box supplied from the factory contains the following:
- reciprocating saw
- blade
TECHNICAL PARAMETERS
Parameter Unit of measurement Value
Catalogue number YT-82280
Nominal voltage [V] ~230
Nominal frequency [Hz] 50
Nominal power [W] 1200
Nominal rotation [min -1 ] 800 - 2800
Maximum cutting thickness
- wood
[mm] 210
- metals [mm] 10
Blade holder All-purpose holder 1/2” (12,7 mm)
Level of noise:
- acoustic pressure
[dB(A)] 83,9 ± 3,0
- power [dB(A)] 94,9 ± 3,0
Vibration (cutting of wood) [m/s 2 ] 15,2 ± 1,5
Grade of protection IP20
Insulation class II
Mass [kg] 3,9
GENERAL SAFETY CONDITIONS
NOTE! Get acquainted with all the instructions below. Failure to observe them may lead to an electric shock, fire or injuries. The
notion of electric tool used in the instructions applies to all the tools which are powered with electric current, both wire tools and
wireless ones.
OBSERVE THE FOLLOWING INSTRUCTIONS
Place of work
The place of work must be properly illuminated and clean. Disorder and poor illumination may be a cause of accidents.
Do not work with electric tools in explosive environments, or those which contain inflammable liquids, gases or vapours.
Electric tools generate sparks, which may cause a fire in case of contact with inflammable gases or vapours.
Do not allow children and outsiders to the place of work. A lack of concentration may result in a loss of control over the tool.
Electric safety
The plug of the power supply cable must fit the mains socket. Do not modify the plug. Do not use any adapters whatso-
ever in order to adapt the plug to the socket. Unmodified plug which fits the socket reduces the risk of an electric shock.
Avoid contact with grounded surfaces, such as pipes, heaters and refrigerators. Grounding of the body increases the risk
of an electric shock.
Do not expose electric tools to precipitation or humidity. Water and humidity which gets into the electric tool increases the
risk of an electric shock.
Do not overload the power supply cable. Do not use the power supply cable in order to carry the tool or to connect and