Manual VIPA System 300S SPEED7
Chapter 1 Assembly and installation guidelines
HB140E - PS - RE_307-1FB70 - Rev. 13/43
1-7
Cabling
The Co Power Supply is exclusively delivered with CageClamp contacts.
Here the DC 24V power supply may be connected.
Danger!
•
Before installation or overhauling, the power supplies must be
disconnected from voltage (pull the plug or remove the fuse)!
•
Installation and modifications only by properly trained personnel!
For the cabling gray connectors with CageClamp technology are used.
You may connect wires with a cross-section of 0.08mm
2
to 2.5mm
2
. You
can use flexible wires without end case as well as stiff wires.
You fix the conductors to the CageClamps like this:
1
2
[1] Rectangular opening for screwdriver
[2] Round opening for wires
The picture on the left side shows the cabling step by step from top view.
1
2
3
•
To conduct a wire you plug a fitting screwdriver obliquely into the
rectangular opening like shown in the picture.
•
To open the contact spring you have to push the screwdriver in the
opposite direction and hold it.
•
Insert the insulation striped wire into the round opening. You may use
wires with a cross-section from 0.08mm
2
to 2.5mm
2
.
•
By removing the screwdriver the wire is connected safely with the plug
connector via a spring.
Overview
CageClamp
technology (gray)
All manuals and user guides at all-guides.com
