Manual VIPA System 300S SPEED7
Chapter 1 Assembly and installation guidelines
HB140E - PS - RE_307-1FB70 - Rev. 13/43
1-5
1
2
3
•
Dismantle the according protection flaps of the
SPEED-Bus plug-in locations with a screwdriver
(open and pull down).
For the SPEED-Bus is a parallel bus, not all
SPEED-Bus plug-in locations must be used in
series. Leave the protection flap installed at an
unused SPEED-Bus plug-in location.
•
At deployment of a DC 24V power supply, install it
at the shown position at the profile rail at the left
side of the SPEED-Bus and push it to the left to
the isolation bolt of the profile rail.
•
Fix the power supply by screwing.
SLOT1
DCDC
CPU
SLOT2
Modules
PS 307S_Co
•
To connect the SPEED-Bus modules, plug it
between the triangular positioning helps to a
plug-in location marked with "SLOT ..." and pull it
down.
•
Only the "SLOT1 DCDC" allows you to plug-in
either a SPEED-Bus module or the Co Power
Supply PS 307S_Co - exclusive together with the
CPU 317S.
•
Fix the modules by screwing.
SLOT1
DCDC
CPU
SLOT2
•
To deploy the SPEED7-CPU exclusively at the
SPEED-Bus, plug it between the triangular
positioning helps to the plug-in location marked
with "CPU SPEED7" and pull it down.
•
Fix the CPU by screwing.
Please regard that only the CPU 31xS may be
deployed at the SPEED-Bus!
Installation
SPEED-Bus-
Module
Installation CPU
without Standard-
Bus-Modules
All manuals and user guides at all-guides.com
all-guides.com
