14
YASKAWA
SIEP C730600 88F MECHATROLINK-III Technical Manual
Note:
The drive has only two ground terminal screw holes. When you connect three options, two options will share one ground
terminal.
5.
Select the proper MECHATROLINK-III dedicated communication cable according to
.
• You can route the option wiring through openings on the front cover of some models. Remove the
perforated tabs on the left side of the front cover as shown in
-A to create the necessary
openings on these models.
• Route the option wiring inside the enclosure as shown in
-B. Take proper precautions so that
the front covers will easily fit back onto the drive.
Refer to the Peripheral Devices & Options section of the drive instruction manual for more information.
Note:
Separate communication cables from main circuit wiring and other electrical lines to avoid potential sources of electrical
interference.
A - Route wires through the
openings provided on the left
side of the front cover.
B - Use the open space provided
inside the drive to route option
wiring.
Figure 5.6 Wire Routing Examples
*1
If wiring is exposed outside the enclosure, the drive will not meet Enclosed wall-mounted type (IP20/UL Type 1)
requirements.
6.
Firmly connect the MECHATROLINK-III communication cable to option communication connector CN1 or
CN2.
Install MECHATROLINK-III communications cables separately from main-circuit wiring and other electrical
and power lines. Ensure the cable end is firmly connected (see
). Refer to
Communications Cables on page 18
for more information.
7.
Reattach the drive front cover (A, C) and the keypad (B).
Refer to the manual packaged with the drive for instructions on how to reattach the cover.
NOTICE
Do not pinch cables between the front covers and the drive. Failure to comply could cause
erroneous operation.
A - Drive front cover
B - Keypad
C - Drive terminal cover
Figure 5.7 Replace the Front Covers and Keypad
