26
YASKAWA
SIEP C730600 0E YAI Modbus TCP/IP Technical Manual
7.
Firmly connect the Ethernet communication cable to the option modular connector CN1 port 1 or port 2.
Isolate communication cables from main circuit wiring and other electrical and power lines. Make sure that
you firmly connect the cable end. (Refer to
). Refer to
Communication Cable Specifications on
for more information.
NOTICE
Damage to Equipment. When you touch the option, make sure that you observe correct electrostatic
discharge (ESD) procedures. If you do not follow procedures, it can cause ESD damage to the drive circuitry.
8.
Reattach the drive front cover (A) and the keypad (B).
Refer to the drive manuals for more information.
NOTICE
Do not pinch cables between the front covers and the drive. Failure to comply could cause
erroneous operation.
A - Drive front cover
B - Keypad
Figure 5.27 Replace the Front Cover and Keypad
9.
Set drive parameters in
Related Drive Parameters on page 27
for correct option performance.
◆
Communication Cable Specifications
Yaskawa recommends using shielded Cat5e cable. The Yaskawa warranty does not cover other cable types.
■
Option Connection Diagram
Figure 5.28 Option Connection Diagram
*1
Connect the specified ground wire for installations on 1000-series, GA500, and HV600 drives. The ground wire is not necessary for
installation on GA700 or GA800 drives.
