1.3 Devices and Components That Are Required to Build a System
1-6
1.3
Devices and Components That Are Required to Build a System
The following table lists the devices and components that are required to build the system that
is shown in
1.2 System Configuration Example
on page 1-5. The numbers 1 to 12 correspond
to the numbers in the figure in
1.2 System Configuration Example
No.
Name
Use
Model
Remarks
MP3300
CPU Module
Stores the module defini-
tions and programs, and
interprets the programs. The
CPU Module also controls
the Optional Modules.
Refer to the following section for details.
Base Unit
Provides the backplane to
which Modules are mounted
and supplies the required
power to the Modules.
Ethernet communica-
tions cables
Used to connect the CPU
Module to Ethernet commu-
nications devices or to con-
nect the CPU Module to a
PC that has the MPE720
installed on it.
Use a commercially available cable that meets
the following conditions:
•
Ethernet specification: 100Base-TX
•
Category 5 or higher
•
Twisted-pair cable with RJ-45 connectors
Battery with Special
Connector
Provides power for the cal-
endar and backup memory
while the power is turned
OFF.
JZSP-BA01
The Battery is provided with
the CPU Module.
Power supply cable
Connects the power supply
of the Base Unit to a 24-
VDC power supply or an AC
power supply.
Use a commercially available cable that meets
the following conditions:
•
Wire size: AWG18 to AWG13 (0.8 to 2.6
mm
2
)
•
Twisted-pair cable
RLYOUT connector
cable
Connects the power supply
of the Base Unit to a 24-
VDC power supply, an AC
power supply, or a status
monitoring device.
Use a commercially available cable that meets
the following conditions:
•
Wire size: AWG28 to AWG14 (0.08 to 2.0
mm
2
)
Front cover for unused
slot
Used to cover unused slots
on the Base Unit.
JEPMC-
OP3301-E
−
Optional Modules
Motion Modules, I/O Mod-
ules, and Communications
Modules are selected based
on the application.
Refer to the following section for details.
MECHATROLINK-III
Cable
Connects the CPU Module
to MECHATROLINK-III com-
munications devices.
JEPMC-
W6012-
-E
Standard cable
Length: 0.2 to 50 m
JEPMC-
W6013-
-E
Cable with ferrite cores
Length: 10 to 50 m
JEPMC-
W6014-
-E
Cable with loose wires at one
end
Length: 0.5 to 50 m
SERVOPACK with
MECHATROLINK-III
Communications
Used to control Servomo-
tors.
SGD7S-
20
Σ
7S (Single-axis)
AC SERVOPACK with
MECHATROLINK-III Commu-
nications
SGD7W-
20
Σ
7W (Two-axis)
AC SERVOPACK with
MECHATROLINK-III Commu-
nications
Continued on next page.
