YASKAWA HV600, Руководство пользователя

Страница: 324 / 610

2.8 H: Terminal Functions
324 YASKAWA TOEPYAIHV6002A HV600 Drive Programming
■
100 to 1C4: Inverse Outputs of 0 to C4
Setting Value Function Description
100 to 1C4 Inverse Outputs of 0 to C4
Causes inverse output of the function for the selected MFDO. Uses the last two digits of 1xx to select which function to inversely
output.
For example, set H2-xx = 10E for the inverse output of E [Fault] .
◆
H3: Analog Inputs
WARNING! Sudden Movement Hazard. Do test runs and examine the drive to make sure that the command references are correct.
If you set the command reference incorrectly, it can cause damage to the drive or serious injury or death.
Drives have two analog input terminals, terminals A1 and A2. H3 parameters select the functions set to these analog
input terminals and adjust signal levels.
Table 2.55 shows the functions that you can set to analog input terminals. Use H3-02 and H3-10 [MFAI Function
Selection] to set functions.
Table 2.55 MFAI Setting Values
Setting
Value
Function Ref.
0 Frequency Reference 329
1 Frequency Gain 330
2 Auxiliary Frequency Reference 1 330
3 Auxiliary Frequency Reference 2 330
4 Output Voltage Bias 330
5 Accel/Decel Time Gain 330
6 DC Injection Braking Current 331
7 Torque Detection Level 331
8 Stall Prevent Level During Run 331
9 Output Frequency Lower Limit 332
B PID Feedback 332
C PID Setpoint 332
D Frequency Bias 332
E Motor Temperature (PTC Input) 332
F Not Used 333
10 Forward Torque Limit 333
Setting
Value
Function Ref.
11 Reverse Torque Limit 334
12 Regenerative Torque Limit 334
15 General Torque Limit 334
16 Differential PID Feedback 334
1F Not Used 334
24 PID Feedback Backup 335
25 PI2 Control Setpoint 335
26 PI2 Control Feedback 335
27 PI Auxiliary Control Feedback 335
2B Emergency Override PID Feedback 335
2C Emergency Override PID Setpoint 335
2D Differential Level Source 335
2E Hand Frequency Ref or Setpoint 335
30 DWEZ Analog Input 1 336
31 DWEZ Analog Input 2 336
Note:
All analog input scaling uses gain and bias for adjustment. Set the gain and bias values correctly.
V/f OLV/PM OLV/PM EZOLV