YASKAWA HV600, Руководство пользователя

Страница: 332 / 610

2.8 H: Terminal Functions
332 YASKAWA TOEPYAIHV6002A HV600 Drive Programming
Figure 2.75 Stall Prevention Level during Run with Analog Input
■
9: Output Frequency Lower Limit
Setting Value Function Description
9 Output Frequency Lower
Limit
Enters a signal to adjust the output frequency lower limit level as a percentage of the maximum output frequency.
■
B: PID Feedback
Setting Value Function Description
B PID Feedback
Enter the PID feedback value as a percentage of the maximum output frequency.
When you use this function, set b5-01 ≠ 0 [PID Mode Setting ≠ Disabled] .
■
C: PID Setpoint
Setting Value Function Description
C PID Setpoint
Enters the PID setpoint as a percentage of the maximum output frequency.
When you use this function, set b5-01 ≠ 0 [PID Mode Setting ≠ Disabled] .
Note:
Configuring this function disables the frequency reference set with b1-01 [Frequency Reference Selection 1] .
■
D: Frequency Bias
Setting Value Function Description
D Frequency Bias
Enters the bias value added to the frequency reference as a percentage of the maximum output frequency.
The drive adds the input value from the MFAI terminal set with this function to the frequency reference as the bias
value.
Note:
When you select d1-01 to d1-17 [Reference 1 to 8 or JOG Frequency Reference] as the frequency reference, it will disable this function.
■
E: Motor Temperature (PTC Input)
Setting Value Function Description
E Motor Temperature (PTC
Input)
Uses the motor Positive Temperature Coefficient (PTC) thermistor to prevent heat damage to the motor as a percentage of the
current value when the 10 V analog signal is input.
• You can use the Positive Temperature Coefficient (PTC) thermistor as an auxiliary or alternative detection function
for
oL1 [Motor Overload] problems to help prevent heat damage to motors. If the PTC input signal is more than the
overload alarm level, oH3 [Motor Overheat (PTC Input)] will flash on the keypad.
• When the drive detects oH3 , the motor stops with the setting in L1-03 . When the drive detects oH4 , the motor stops
with the setting in L1-04 . When the drive incorrectly detects motor overheating problems, set L1-05 .
V/f OLV/PM OLV/PM EZOLV
V/f OLV/PM OLV/PM EZOLV
V/f OLV/PM OLV/PM EZOLV
V/f OLV/PM OLV/PM EZOLV
V/f OLV/PM OLV/PM EZOLV