Yanmar BY series, Руководство по обслуживанию

Страница: 254 / 275

ELECTRICAL AND ECU
BY Service Manual 12-27
Repair
Replacing Crankshaft Sensor
1. Disconnect battery negative (-) cable.
2. Remove starter motor. See Remove and Install
Starter Motor on page 10-7.
Figure 12-28
3. Disconnect harness connector from crankshaft
sensor connector (Figure 12-28, (1)) .
4. Remove connector from mounting bracket
(Figure 12-28, (2)) .
5. Remove screw (Figure 12-28, (3)) and remove
sensor from engine.
6. Install sensor and tighten screw
(Figure 12-28, (3)) to 9.5 N·m (84 in.-lb).
7. Install connector in bracket and connect engine
harness.
8. Install starter motor. See Remove and Install
Starter Motor on page 10-7 .
9. Check and delete any trouble codes that are
registered in the ECU after the work has been
completed
.
Replacing Camshaft Sensor
Figure 12-29
1. Disconnect harness connector
(Figure 12-29, (1)) .
2. Remove screw (Figure 12-29, (2)) and remove
camshaft sensor.
Figure 12-30
3. Check condition of seal (Figure 12-30, (1)) and
replace if necessary.
4. Install sensor and tighten screw to 2.3 N·m
(20 in.-lb)
5. Check and delete any trouble codes that are
registered in the ECU after the work has been
completed
.
(
3
)
(2)
(1)
000 3 770
(2)
(1)
000 3 769