Operating
9
YZ-X9
Manual
Operating machine
1. Turn the main power key to (I) position.
2. Pull down the squeegee lift lever to lower the squeegee assembly to the
ground.
3. Step on the brush head lifting pedal to lower the brush head to the ground.
4. Turn on the water control knob.
5. Press the switch of the brush plate motor, and then press the switch of the
suction motor.
6. Motor-driven model: adjust the speed control knob to the cleaning speed
you want
Note: It is recommended to use a cleaning speed of 45-60 meters per minute.
During operation of the machine
Warning: Risk of fire or explosion. Do not pick up flammable materials or
reactive metals.
1. Each cleaning path overlaps by 5 cm.
2. Keep the machine moving so as not to damage the ground.
3. If there are drag marks on the ground after the squeegee absorbs water,
wipe the tape with a rag to remove the garbage. Clean in advance to prevent
drag marks.
4. Do not operate the machine on an inclined surface with a slope of more
than 5% (3°).
For safety: When using the machine, please move slowly on slopes and
slippery surfaces.
5. If there is too much foam, pour the recommended defoamer solution into
the recovery tank.
Note: Do not let foam enter the filter to avoid damage to the vacuum motor.
Foam will prevent the filter switch from failing
6. Use double cleaning to clean extremely dirty areas. First raise the squeegee
for cleaning, let the solution soak for 3-5 minutes
After the clock, lower the squeegee and clean it again.
7. Replace or rotate the pad as needed.
8. Observe the power consumption of the battery power meter (refer to "
Battery Power Meter").
9. Check the remaining liquid volume through the clean water tank level
gauge. The amount of traditional washing method is about 10 liters per 10
minutes;
10. When the solution in the clean water tank is used up, first empty the
recovery tank and then refill the solution.