INSTALLATION OF PANEL
Unload air-in grille
Take off air-in grille
Unload panel installation cap
INSTALLATION OF PANEL
4.Adjust the location and direction of panelto tally
louver of panel with outlet of
outdoor,screw
all the bolts fasten to
make the panel and
outdoor unit
3.Then screw the other two M6*20 bolt with M10
gasket
2.Please
connect
step
motor
wire,display
board
wire
to
the
electrical
box
according
to
ELECTRIC
WIRING
DIAGRAM
on
theelectrical
1.Please
screw
M10
gasket
and
M6*20
bolt
at
the
corner
of
indoor
unit,
before
screwing
them
fasten,screw
other
two
additional
bolt
swhich
locatesred
bolt
showin
gas
figure
and
notice
that
the
direction
of
red
arrow
on
theelectrical
box
aligns
the
one
on
the
panel.
box.
through the hole of panel into outdoor unit.
pressed together.
5.Return the air-in grille and panel back
to the
outdoor unit.
BODY DIMENSION:
Please refer to the following figures to install.
The following figure only shows the assembly relationship of the indoor unit ,outdoor
unit and refrigerant pipes.
The throttle subassembly
been installed in the outdoor unit..
Use two spanners to connect the pipe with indoor/outdoor pipes to avoid the copper pipe cracking.
Please pay attention to the connection orientation when connecting.
has
Use a vacuum pump, to vacuum from the gas side refrigerant adding mouth of the outdoor
unit.
Don t use the refrigerant of the outdoor unit to do the vacuum. (A certain volume of refrigerant
had been added into the outdoor unit in factory.)
’
Air and moisture remains inside the refrigeration system, may has the following bad effects:
Rise of pressure inside the refrigeration system;
Decrease of cooling (or *heating) effect;
Moisture frozen and blocking the refrigeration system;
Rusting of certain parts of the system
After connecting the indoor and outdoor units , it is necessary to exhaust the air inside the
pipes completely as follows:
13
Содержание YC12T1/I
Страница 4: ...01 03 04 05 06 13 15 16 18 21 26 27 29 32...
