Yamato YC12T1/I, Руководство по установке и эксплуатации

Страница: 12 / 38

While the unit is in operation, you can adjust the air flow louver to change the flow direction and natu-
ralize the room temperature evenly. Thus you can enjoy it more comfortably.
1.Set the desired air flow direction.
Push the SWING button to adjust the louver to the desired position and push this button again to
maintain the louver at this position.
2.Adjust the air flow direction automatically.
Push the SWING button, the louver will swing automatically..
While this function is set,the swing fan of indoor unit runs;otherwise,the swing fan doesn t run.The
swing scale of every side is 30 .When the air conditioner isn t in operation(including when TIMER
ON is set),the SWING button will be disabled.
MAINTENANCE
Before you clean the air conditioner, be sure to disconnect the power supply plug.
Use a dry cloth to wipe the indoor unit and remote controller.
A cloth dampened with cold water may be used on the indoor unit if it is very dirty.
Never use a damp cloth on the remote controller.
Do not use a chemically-treated duster for wiping or leave such material on the unit for long,
because it may damage or fade the surface of the unit.
Do not use benzine,thinner,polishing powder,or similar solvents for cleaning. These may
cause the plastic surface to crack or deform.
Cleaning the indoor unit and remote controller
If you do not plan to use the unit for at least 1 month.
(1) Operate the fan for about half a day to dry the inside of the unit.
(2) Stop the air conditioner and disconnect power.
(3) Remove the batteries from the remote controller.
ADJUSTING AIR FLOW DIRECTION
Cassette Type
ADJUST UP AND DOWN
HEIGHT BETWEEN CEILING AND FLOOR
INSTALLATION SPACE
C
Wall
material
Up(B)
Sides(C)
Above 5cm Above 5cm Above 5cm
Above 100cm Above 100cm
Flammable
material Fire-proof
structure
Fire-proof material
or other nonflammable
materials other than
metal
Ceiling
Above 270cm
Above
100cm
Above
100cm
Obstacle
The installation height between ceiling and floor must be 2.7m~3.2m.
A>330mm
Bolt with M10 whorl is to be used. The center distance between the bolts is decided by the size of the
unit . Use the following method to install:
Installation method should be changed under the different construction structure. Please consult
the professional for the detailed information.
After opening a hole, the ceiling should be horizontal and strong to prevent vibration.
Cut the beams at the hole and remove them.
Reinforcing the beams that have been cut and the beams fixing the ceiling .
Preparation Work on the Ceiling
1
2
CEILING HOLE AND THE HOOK INSTALLATION
Installation of the hanging screw bolt
!
WARNING
!
CAUTIONS
8